ENFORCer Outd oor Stan d-Alone Keypads 2 SECO -L ARM U.S.A., Inc. Features Table of Contents Specifications 12~24 VDC/VAC operation. 1,010 User codes. 2 Form C relays, each rated 1 Amp @ 30VDC. Each relay has programmable output time from 1~99 seco nds or toggle. Output #2 can be programmed for use with a doorbell.
Show more
See More
Download ENFORCer SK-983A Installation manual 1 2 A. T o program the keypad for Quick Code: 3289* The keypad is now in the programming mode, ready to receive new data. 42# Set the relay to latch ON when the Quick Code is inputted. * Exit the programming mode. B. Now the relay will be latched ON when the first 2 digits of the User Code are inputted.
Show more
See More
View online Manual for ENFORCer SK-1011-SDQ Keypad or simply click Download button to examine the ENFORCer SK-1011-SDQ guidelines offline on your desktop or laptop computer.
Show more
See More
View online Manual for ENFORCer SK-2323-SDAQ Keypad or simply click Download button to examine the ENFORCer SK-2323-SDAQ guidelines offline on your desktop or laptop computer.
Show more
See More
Download ENFORCer SK-983A Installation manual. 1. 2. Figure 3: Programming the SK -983A Keypad. Figure 1: Visible and Audible Indicators. The built-in buzzer and the amber LED generate tones and. signals to indicate programming status as shown in Figure 1.
Show more
See More
Proceed to the EnfoRCer keypad, which will display (from power up): 1. Once power has been applied to the EnfoRCer, 'Please Wait' will be displayed, followed by '485 Comms Lost'. After approximately one minute, the EnfoRCer will the time on the display, indicating the system is ready to use. 2. The EnfoRCer is defaulted to keypad address '0'.
Power up the EnfoRCer system, an alarm will be generated. Proceed to the EnfoRCer keypad, which will display (from power up): 1. Once power has been applied to the EnfoRCer, 'Please Wait' will be displayed, followed by '485 Comms Lost'.
Power up the EnfoRCer 32-WE system, an alarm will be generated. Proceed to the nearest keypad, which will display (from power up): 1. Once power has been applied to the EnfoRCer 32-WE (see page: 37). 'Please Wait' and then '485 Comms Lost' will be displayed.
Enter the programming mode by keying in the master code and the key, then enter the refresh code, and the key: The keypad is now in the programming mode. All old data is cleared and the keypad is ready for new data. NOTE: The master code does NOT change.