CARE AND MAINTENANCE OF KEROSENE HEATER WICKS
Show more
See More
4. Kerosene Heater Flickering Flame This is a very common problem. You light the heater, and it comes on nicely. However, the flame soon begins to flicker, resulting in abysmal heat output. Sometimes the flame may even go out completely, leaving you in the biting cold. The problem often emanates from a bad wick.
Show more
See More
Flame Flickers or Goes Out Drain the fuel tank and remove the wick assembly. Replace the wick and wick assembly and refill the fuel tank with kerosene. Allow it to burn dry until the flame starts to go out. Raise the wick as high as it will go and allow the heater to burn until the flame goes out.
Show more
See More
If you are experiencing a flame that is flickering or frequently going out, then you will want to drain the fuel tank and remove the wick. Replace the wick with a new one and refuel the tank with K-1 kerosene. When you light the wick: Allow it to burn dry until the flame dims.
Show more
See More
Flame Flickers or Goes Out Drain the fuel tank and remove the wick assembly. Replace the wick and wick assembly and refill the fuel tank with kerosene. Allow it to burn dry until the flame starts to go out. Raise the wick as high as it will go and allow the heater to burn until the flame goes out.
Show more
See More
Dec 18, 2019 . You’ve set the wick too high or too low. This is a very common problem – the wick should always be set at the appropriate height of half an inch (1.3 cm). When your kerosene heater is burning you should keep an eye on the wick’s height at least once every hour. The fuel you’re burning isn’t of …
Show more
See More
If you face a problem where your kerosene heater ignites without any issues but goes out after a short while. The below steps will troubleshoot the issue. Start by emptying the tank of all its fuel and take out the wick assembly. You’ll need to replace the wick assembly and the wick as well.
Show more
See More
Sep 11, 2012 . Heater Won’t Light. Remove the cap on the fuel tank and check to see if the tank contains fuel. Refill the tank with kerosene if needed. Replace the batteries for the igniter plug if …
Show more
See More
A low flame, flickering flame, tar deposits, and difficulty turning the knob are some of the signs you have a bad wick. Clean the wick as needed : Time when the fuel is almost used up, raise the flame to use up all the remaining fuel, wait for the heater to cool down, then remove the heater cover.
Show more
See More
Dec 31, 2010 . Purchased a used torpedo heater -- has some kerosene in it. When I plugged it in, it would start and then in a couple of seconds, it would cough and sputter and quit with lots of smoke. The spark plug is glowing and shuts down shortly causing the flame out.
Show more
See More
If you are sure of your kerosene and your heater is giving off sooty black smoke it is a sign that the fuel/air mix is off. Make sure your heater is not in a draft. Too much air …
Show more
See More
Cause. Solution. Heat chamber tilted or improperly seated. Move wire handle until heat chamber is properly seated and moves smoothly left and right. Wick is set too high. Reduce wick height by turning wick adjuster knob counterclockwise. Dirty wick. Clean wick as described in "Wick Tips".
Show more
See More
A heater may still light with insufficient soaking, however, air bubbles develop in the capillaries of the wick, preventing the proper flow of kerosene. Be sure to soak the wick in the down position in a full tank of fuel for at least 60 minutes.
Show more
See More
Modern kerosene heaters are radiant (with reflector) or convection (air flow-through) types. What Can Go Wrong with a Kerosene Heater? The wick may need replacing or reconditioning. The heater may not light. The flame may flicker or die. The flame may smoke or smell. The wick may burn too quickly. The wick adjuster may stick.
Show more
See More
May 08, 2018 . It's probably the kerosene. If it's old it will do this. Try a new wick with fresh kerosene and see how that works. As kerosene ages it loses it's burn quality.
Show more
See More
IF A WICK WILL NOT LIGHT OR STAY LIGHTED. The usual problem with a wick not lighting is that it has absorbed water from the fuel. A kerosene heater stored over the summer with fuel in the tank, even a little fuel, can induce condensation.
Show more
See More
Dec 27, 2012 . Poor flame, sounds of combustion, soot at the rear of the heater. Loose flue pipe. Allow heater to cool completely; tighten all connections. Soot on inside of burner window or exhaust ports of flue pipe. Obstruction of combustion air intake system or combustion fan failure. Inspect air intake system and air supply elbow for blockage.
Show more
See More
May 02, 2010 . Kerosene Heater Information: This year I have had many reports of flame "dwindling" or poor performance of heaters. This is caused by poor capillary action, the result of water in the fuel: It only takes a teaspoon of accumulated water to saturate the cotton lower portion of a wick.
Show more
See More
Advantages of kerosene heater. Heating with kerosene. Visit us at http://www.genewoodshop.com
Show more
See More
The primary cause is water in the wick or contaminated fuel. While sitting unused, the wick can absorb enough fuel to light and burn for up to 20 minutes or so, then the capillary action is insufficient to sustain the burn. This is covered below.
Whether you’re having kerosene heater wick problems or trouble with the knobs – even an innocent-looking problem may prove to be disastrous with this type of heating device. So, let’s go over the most common kerosene heater problems and how to fix them.
Light the kerosene heater with little kerosene in the fuel tank. Allow it to burn dry until the flame starts to go out. Raise the wick as high as it will go and allow the heater to burn until the flame goes out.
As for a foul smell, it might be caused by the type of fuel your unit is burning. Lower quality fuel often has a bad odor. Plus, if the wick is installed too low, the fuel does not burn completely, causing that smell. This can be fixed by upgrading to better fuel or raising the wick.
Part 1 of 3: Finding the Proper Place of Disposal Look up your local hazardous waste collection site. If you decide that you want to dispose of your kerosene, you'll need to find a household hazardous waste collection site ... Call you local disposal companies. First, ask them if they accept kerosene. ... Use collection days to have unused kerosene picked up. ... More items...
If your gas water heater keeps shutting off, the thermocouple could be dirty, bent or damaged. The thermocouple is usually easily visible next to the pilot light.
Kerosene Heaters can be wonderful and very useful. They are safer than other gas heater types, and kerosene itself is considered safe to use most of the time. Although too much of it can cause carbon monoxide poisoning, you're at very low risk of this.