Lamberti Elektronik User Guide

Listing Results Lamberti Elektronik User Guide

Frequently Asked Questions

• How do I change the language of the 7000 series oscilloscope help?

  To select this mode, press the Utility key, then press the Languagesoftkey, then press the Help Close on Release/Remain on Screensoftkey (UtilityLanguageHelp). Press and Hold Front Panel Key or Softkey (or Right-Click Softkey when using Web browser control) Quick Help Message 7000 Series Oscilloscope User’s Guide 53 Quick Help Languages

• Why can’t I decode SPI signals in the 7000 series oscilloscope?

  NOTEBecause of oscilloscope hardware resource limitations, you cannot decode SPI data while CAN or LIN triggering is selected. NOTEFor SPI triggering setup see page 180. Display decode Decode mode Signal setup menu Return to previous menu SPI word size 7000 Series Oscilloscope User’s Guide 307 2Specify the SPI signals:

• How do I set the SCL label on my oscilloscope?

  As you press the SCLsoftkey (or rotate the Entry knob on mixed-signal oscilloscopes), the SCLlabel for the source channel is automatically set (press the Labelkey on the front panel to switch labels on) and the channel you select is shown in the upper-right corner of the display next to “I2C”.

• How do I set the minimum test time of my oscilloscope?

  Minimum TimeChoose this option and then use the Test Time softkey to select how long the oscilloscope will run. When the selected time has passed the oscilloscope will stop. The specified time may be exceeded. If an error occurs the action specified using the On Errorsoftkey will occur. The actual test time is displayed above the softkeys.