The following manuals provide reference material for customers with older products. Complete User Manual - GEN I. Harley Touring - GEN II (Old Mount) Install 93-08 Harley Touring - GEN I. Install 09-UP Harley - GEN I. Install 87-UP Softail - GEN I. Install 04-UP Sportsters - GEN I. Install 01-UP GL1800 - GEN I.
Show more
See More
OPERATING INSTRUCTIONS Before operating, identify the mounting style of your landing gear — Inside or Outside Mount (See figures below). EXTEND CLOCKWISE OUTSIDE MOUNT • Push crank handle in for low speed. • Pull crank handle out for high speed. • Turn crank: counterclockwise = retract clockwise = extend EXTEND COUNTER CLOCKWISE INSIDE …
Show more
See More
Owner's Manual Version Language Order. CS6115 Replaceable Landing Gear Operating, Maintenance and Repair Procedures. English. XL-LG321. (273 kb) Formula 150 - model LG150-1C9-CS502 Operating, Maintenance and Repair Procedures. English.
Show more
See More
Upload User Manual Have you got an user manual for the DJI Flame Wheel F450 with Naza-M V2, GPS, and Landing Gear in electronic form? Please send it to us and help us expand our library of instruction manuals. Thank you, too, on behalf of other users. To upload the product manual, we first need to check and make sure you are not a robot.
Show more
See More
Rotate the landing gear leg until it is fully seated into the connector. 3. Connect both springs to the center frame and the landing gear legs. Mind your fingers when mounting the springs. Note the orientation Note the Orientation 1 2 Attach Unfolding the Aircraft 1. Gently lift the frame arm. Twist the red knob to lock each arm in place.
Show more
See More
User manual instruction guide for Nose Landing Gear Axle Remote Data Concentrator 142145 ELDEC Corporation. Setup instructions, pairing guide, and how to reset.
Show more
See More
Connect the Intelligent Landing Gear to the flight controller’s F1 port, and then configure the settings in DJI Assistant -> DJI Device -> Gear page. 3S-12S A3/A3Pro ©2016 DJI. All Rights Reserved. 17
Follow the steps below to use auto-landing: 1. Ensure the aircraft is in “P” mode. 2. Check the landing area condition before tapping “ ”, to perform landing. 3. Aircraft lowers the landing gear and proceed to land automatically. Updating the Home Point There are two ways for updating the Home Point. 1.
You can use a switch to raise or lower the Intelligent Landing Gear. Mounting and Cable Connection Ensure the battery is powered off before connection. Connect the Intelligent Landing Gear to the flight controller’s F1 port, and then configure the settings in DJI Assistant -> DJI Device -> Gear page.
Landing Gear Handle. The landing gear is controlled by a two -position, wheel shaped handle on the lower left side of the main instrument panel. Two conditions must be met before the gear can be raised: the aircraft must sense that weight is off all three landing gear and the launch bar must be retracted. |G| 3. Launch Bar Switch.
People cannot believe how strong the supports are and how stable the bike is with them deployed. Please contact us with any questions at 407-834-5007 or Info@Landingear.com . DEALER INQUIRIES INVITED!
Over ten years ago, Chopper Design introduced the original LegUp™ Landingear system. Since then, thousands of riders have been helped by it's ability to stabilize their bikes at slow speeds. The GENERATION II system we use today is significantly stronger than it's older brother.
That is why we came up with LegUp™ Landingear! The Patented LegUp™ design was created for those who for whatever reason are concerned about, or unable to hold up these 850 lb monsters as they come to a stop.