Show more
See More
Floor Under Solids or Semi- solids and Single Axle load (15,000 LBS. or >) The minimum floor thickness shall be 6 inches. The minimum shrinkage and temperature reinforcement shall be as per Table 4. Steel shall be located within 2” of the top or the upper 1/3 of the slab. The minimum Sub-Base thickness shall be as shown in the table.
Show more
See More
Mar 20, 2017 . These designs may store up to 500,000 pounds NEW of hazard division 1.1, however some approved designs are based upon a lower storage capacity. "3-Bar" Designs The headwall and doors of a 3-Bar ECM provides a lower level of blast resistance than a 7-Bar ECM resulting in more restrictive siting separation distances.
Show more
See More
The load combination used for The Foundation Design Footing Tables (Appendix B, Part 1) is: DL (heavy) + LL (occupancy) + LL (attic) + SL (or min. roof LL). The load combination used for The Foundation Design: Anchorage Ta-bles (Appendix B, Part 2,3,4) is: (Wind or Seismic*) ± DL (light)
The overall architecture of Cisco LBS is shown in Figure 15-1 . Access points forward received signal strength information to WLAN controllers with regard to the observed signal strength of any Wi-Fi clients, 802.11 active RFID tags, rogue access points, or rogue clients.
DESIGN GUIDE ECONOMICAL LOAD TABLES 001_168 3/28/07 11:07 AM Page 24 Service Service ASD 1/240 1/360 ASD 1/240 1/360
All rows of bridging shall be diagonal bridging with bolted connections at the chords and intersections. Where the joist span is inBLUE the SHADEDarea of the load table hoisting cables shall not be released until the two rows of bridging nearest the third points are completely installed.
The Cisco Unified Wireless Network solution offers secure, scalable, cost-effective wireless LANs for business critical mobility. The Cisco Unified Wireless Network is the industry’s only unified wired and wireless solution to cost-effectively address the wireless LAN (WLAN) security, deployment, management, and control issues facing enterprises.
The "Location Tracking Approaches" section of Wi-Fi Location-Based Services 4.1 Design Guide provides a foundation in the technical aspects of traditional location tracking and positioning systems.
The Cisco Wireless Location Appliance and the Cisco WCS are part of the Cisco Unified Wireless Network with each deployed as a separate hardware component for optimum scalability and maximum flexibility.
Voice Services—Brings the mobility and flexibility of wireless networking to voice communications via the Cisco Unified Wired and Wireless network and the Cisco Compatible Extensions voice-enabled client devices.