Leadshine India - sales and service of stepper drives, stepper motors, motion controller, servo drives and servo motors. +91.9892203008 support@Leadshineindia.com
Show more
See More
Leadshine Easy Servo Series Manuals & User Guides User Manuals, Guides and Specifications for your Leadshine Easy Servo Series Servo Drives. Database contains 1 Leadshine Easy Servo Series Manuals (available for free online viewing or downloading in PDF): Hardware installation manual .
Show more
See More
Leadshine ELP Series Manuals & User Guides User Manuals, Guides and Specifications for your Leadshine ELP Series Controller. Database contains 1 Leadshine ELP Series Manuals (available for free online viewing or downloading in PDF): Operation & user’s manual .
Show more
See More
If you are upgrading to the 8.7 HP Plug and Play Spindle / VFD system, ensure you use the new 14-pin cable that came with your 8.7 HP system. If you choose to house your MX4660 in an enclosure, the included strain relief can be used to affix the SP/THC Cable to your control unit. Simply install it in any unused hole of appropriate size in your ...
Show more
See More
Leadshine America, Inc. Address: 26050 Towne Centre Dr. Foothill Ranch, CA 926 USA Tel: 1-949-608-7270 Fax: 1-949-608-7298 Web: www.Leadshineusa.com Sales: sales@Leadshineusa.com Support: support@Leadshineusa.com CS Series Closed -loop Stepper Drives Software Manual V3.1 CS Series Closed -loop Stepper Drives Software Manual V3.1 Notice
No part of this manual shall be reproduced, stored in retrieval form, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise without approval from Leadshine. While every precaution has been taken in the preparation of the book, Leadshine assumes no responsibility for errors or omissions.
Leadshine’s ES-M series easy servo motors, or stepper motors with encoders, are designed to work with Leadshine’s easy servo drives including the ES-D508, ES-D808 and ES-D1008. They are currently available from NEMA23 to NEMA34 with holding torque from 1 Nm to 8 Nm.
Prerequisites Leadshine ProTuner for CS-D closed loop stepper drives is a free Windows based software. To successfully run this software, the following prerequisites must be satisfied. 2.1 Operation System This ProTuner software must be installed and run on a computer with Windows 7 or Window 10 operating system for either 32 or 64 bit.
By taking step & direction commands, the MX4660 can be easily controlled by motion controllers, PL\u0012窶冱, \u0012N software (e.g. Mach 3/4, EM)窶ｦ.
Hardware Manual for Leashine MX4660 4-Axis Stepper Drive with reakout oard & I/O窶冱 ii Notice Read this manual carefully and the MX4660 datasheet before any assembling and using. Incorrect handling of products in this manual can result in injury and damage to persons and machinery.
Download driver software Hardware installation manual for MX4660. Leadshine MX4660 is a 4-axis stepper drive with built-in breakout board and I/O's. It is specially designed to allow EASY and RAPID implementation for full control of 4 stepper motors of frame sizes 17, 23, 24.