Nat Service Manual

Listing Results Nat Service Manual

Frequently Asked Questions

• What do I need to know about 18th chapter of Nat?

  NORTH ATLANTIC OPERATIONS AND AIRSPACE MANUAL CHAPTER 18 Nat Doc 007 112 Edition 2013 Operators must check the specific requirements of their State of Registry and or the relevant North Atlantic Air Traffic Services Provider States. Navigation Equipment

• Where do I Send my North Atlantic central monitoring agency form?

  When complete send this form to: North Atlantic Central Monitoring Agency c/o National Air Traffic Services Room G41 Scottish & Oceanic Area Control Centre, Sherwood Road, Prestwick, Ayrshire - KA9 2NR Natcma@Nats.co.uk Page 2 of 2 NORTH ATLANTIC OPERATIONS AND AIRSPACE MANUAL ATTACHMENT 4

• What equipment is required for unrestricted operations in Nat?

  For unrestricted operations in the Nat Region fully functioning HF Communications equipment is required. While SATCOM Voice and Data link communications are being gradually introduced into Nat operations, HF may still be required as back-up. NORTH ATLANTIC OPERATIONS AND AIRSPACE MANUAL CHAPTER 17

• What is the scope of the Nat Doc?

  The scope of the Nat Doc.007 has been expanded in this Edition to incorporate guidance for Operators and Regulators of flights within the North Atlantic Region at levels below FL285. The vast majority of this additional content was previously published in the North Atlantic InterNational General Aviation Operations Manual.

• How do I change my Nat settings on my router?

  Click the "Administration" link on your router. Change the "UPnP" setting from "Disabled" to "Enabled.". Click the "Save Settings" or "Save Changes" button at the bottom of the page. Exit your router configuration tool.

• Can I configure Nat with static route?

  To configure static Nat with route maps, use the following steps: 1) The first step in any Nat configuration is to define the inside and outside interfaces. This can be done by issuing the ip Nat inside command and the ip Nat outside command under the specific interface configuration mode.