Naturewater User Manual

Listing Results Naturewater User Manual

Frequently Asked Questions

• Can I get an instruction manual for my water softener?

  Western Water Products, who makes your water softener, will be glad to give you an instruction manual for your model, most likely at no charge. Illustration: a Whirlpool WHES33 type water softener rotor and seal kit as widely sold on eBay and by plumbing suppliers and water softener parts suppliers.

• How does Natura’s water filter work?

  Water has never tasted so good. Natura’s three-step process to rid your water of sediment and biologics begins with an NSF-certified sediment filter, clearing your drinking water of debris and organisms 5 microns and larger. The next step in the filtration journey introduces an NSF Standard 53-certified carbon filter.

• What is Natura water?

  Natura® Water is a leader in delivering an endless supply of pure, fabulous-tasting, chilled still, chilled sparkling, and still ambient water. Our patented three-stage advanced filtration process turns your tap water into fine refreshment while retaining healthy, thirst-quenching minerals.

• Does the start-up system require a natural2 mineral control?

  THIS SYSTEM INCLUDES A START-UP CARTRIDGE REQUIRES A NATURE2MINERAL CARTRIDGE AFTER START-UP PERIOD (not included, see page 11 for more information) Page 2Nature2®Fusion Inground Installation and Operation Manual

• When should a booster pump be installed on a water softener?

  The DuraMAC booster pump should be installed after the water meter, and before the water softener. If debris is pres- ent in the water, a strainer of 40-50 mesh should be installed before the pump and cleaned regularly.

• What is the duramac™ water pressure booster system?

  The DuraMAC™ Water Pressure Booster System is the first booster pump of its kind to be designed for virtually all residential and small commercial boosting applications. In Pressure Mode, the pump starts with pressure drop and stops on low flow. In Flow Mode, the pump starts and stops by sensing flow.

• How do I install the duramac booster pump?

  The DuraMAC booster pump should be installed after the water meter, and before the water softener. If debris is pres- ent in the water, a strainer of 40-50 mesh should be installed before the pump and cleaned regularly. When connecting to a pressurized supply line, make sure the incoming pressure is less than that listed in the table on page 3.

• How to use a pupump pump?

  PUMP STARTS ON PRESSURE PUMP STOPS ON LOW FLOW START PRESSURE INSTRUCTIONS UNDER ROUND COVER TO CLEAR A FAULT, CHECK FOR FLOW, THEN DECREASE START PRESSURE AND PUSH RESET AIR PRESSURE IN TANK SHOULD BE 2 PSI LESS THAN START PRESSURE FOR INDOOR USE ONLY 15000 PC1 DuraMAC PUMP CONTROL 120VAC 60HZ 10 FLA 60 LRA