ODOREME

Listing Results ODOREME

Frequently Asked Questions

• What should I do when ODME is stopped?

  For each time ODME is stopped, we need start Cleaning cycle for ODME system. Have 2 wat to start: automatic or manual. Once the ODME operation is completed, we can close all the valves and electric power. Pls remember to record into a Log book. Pls read The ODME manual before use to avoid damaged system.

• Do you have to wait 24 hours for ODME to start?

  The operator need to wait more 24 hours of settling time to start the ODME again. Now to have the water separate out from oil, we need to allow it 24 hours. A recirculation this would have churned. But if the ODME had stopped because of some error, if the water level was still high, there is no need to wait for 24 Hour for settling time.

• How is ODME required in Marpol Annex 1?

  ODME is required under Marpol Annex I, which deals with pollution aspects related to oil cargoes. For easy understand how does it work? We will take an example: a product tanker of 21.8000 DWT which has just discharged an oil cargo of 15000 MT (16000 m3 @ 15 C). This tanker need to clean these tanks which were carrying total oil cargo of 15000 MT.

• How does a ship crew operate an ODME?

  How does ship crew operate ODME??? ODME is required under Marpol Annex I, which deals with pollution aspects related to oil cargoes. For easy understand how does it work? We will take an example: a product tanker of 21.8000 DWT which has just discharged an oil cargo of 15000 MT (16000 m3 @ 15 C).

• What happens to the odometer if the speedometer is set to 5 miles?

  The odometer cannot be reset. NOTE: The odometer on the speedometer portion of this instrument will show some mileage less than 5 miles (8km). This is a result of factory testing to ensure optimum quality. TIP: Auto Meter always recommends performing the calibration process for best speedometer accuracy.

• How do you reset the odometer on a car?

  Press the Trip button on the dial window to cycle between odometer, Trip 1, and Trip 2 displays on the LCD. Pressing and holding the Trip button for more than 2 seconds while viewing either Trip display will reset the trip currently being displayed. The odometer cannot be reset.

• What is the best way to program an odometer without a programmer?

  Program the Unit The unit is shipped from the factory with a Revs/Mile value of 999.9. This display indicate that the unit has NOT been programmed. It must be programmed before you use it for mileage recording. WGCVS electronic hub odometer does not need a dedicated programmer.

• What do you mean by odometer, MXS, and AVS?

  ODO:Odometer (Total Distance) 3. DST: Trip Distance (One-Time Mileage) 4. MXS:Maximum Speed 5. AVS:Average Speed 6. TM: Elapsed Time (Riding Time) 11. Set Tyre Circumference (Measure the diameter of wheel, multiply by 3.14, get the perimeter of wheel)