Oldfield Amplifiers Design Guide

Listing Results Oldfield Amplifiers Design Guide

About 16 results and 4 answers.

Oldfield Amplifiers – For Players Passionate About Tone

The Oldfield Series 64 OD models can be built in a variety of power configurations starting with the 20W 6420-OD up to the 80W 6480-OD. Each of these models …

Show more

See More

Oldfield Amps The Gear Page

Aug 31, 2009 . Club Deluxe- The best blackface tone you can think of. 2 6v6 goodness with tremolo. A much more focused tone then the original and we actually a/b'd them between the …

Show more

See More

About – Oldfield Amplifiers

At Oldfield Tube Amplification we focus on tone, quality and customer relationships. Our goal is to inspire you. Since 2005 we have been hand-crafting every amplifier one at a time, using …

Show more

See More

Oldfield Amplifiers - Facebook

Oldfield Amplifiers, Charlotte, North Carolina. 1,090 likes. Custom guitar amplifiers.

Show more

See More

Oldfield Tube Amplification Soundpure.com

At Oldfield Tube Amplification we focus on tone, quality and customer relationships. Our goal is to inspire you. We hand-craft every amplifier, using vacuum tube circuitry and the highest …

Show more

See More

Oldfield Club 80 Faulk Vintage Amps & music gear Reverb

Handwired in Charlotte NC. Turret board wiring with high quality components. Based around the 60's blackface design with smooth creamy clean tones. 4-6L6 power output. Switchable from …

Show more

See More

Frequently Asked Questions

  • Are there any equations for op amp design?

    Similar equations have been developed in other books, but the presentation here empha- sizes material required for speedy op amp design. The ideal op amp equations are devel- oped in Chapter 3, and this chapter enables the reader to rapidly compute op amp transfer equations including ac response.

  • Can I iddis the quiescent current draw for multiple op amps?

    There are exceptions, however, such as data sheets that cover single and multiple packaged op amps of the same type. In these cases, IDDis the quiescent current draw for each amplifier. In op amps, power consumption is traded for noise and speed. 11.3.12 Slew Rate at Unity Gain

  • How to design an AIA op amp?

    Enough information exists for the AIA to be designed. The TLV247X op amp is selected because it meets all the system requirements. The first step in the design is to determine the AIA input and output voltages, and this has already been done. These voltages are taken from Tables 12– 1 and 12– 2, and repeated here as Table 12– 4.

  • When should the gain of an op amp be distributed?

    When low-distortion sine waves are required at all outputs, the gain should be distributed be- tween all of the op amps. The noninverting input of the gain op amp is biased at 0.5 V to set the quiescent output voltage at 2.5 V for single supply operation, and should be ground for split supply op amps.

Have feedback?

If you have any questions, please do not hesitate to ask us.