Painless Performance Products Use Manual

Listing Results Painless Performance Products Use Manual

Frequently Asked Questions

• Why choose painless performance products?

  You have purchased what we at Painless Performance Products believe to be the most up-to-date and easiest-to- install automotive wire harness on the market. It is designed for easy installation, even if you have no electrical experience. All kits have a built-in-anti-theft feature.

• What if anything is missing from my painless wire harness kit?

  If anything is missing, contact the dealer where you obtained the kit or Painless Performance at (800) 423-9696. The Painless Wire Harness Kit should contain the following items: AThe Main Wire Harness, divided into 7 rolled bundles, 8 if using 30021 B 2 Headlamp Connector Cables. (Extra Headlamp Cables are available separately under P/N 80300.)

• Why choose painless performance products torc transmission controller system?

  Painless Performance Products thanks you for your purchase of this TORC Transmission Controller System. We strive to provide the most reliable, well designed, vibration resistant and simple to program transmission control system on the market. It was designed for ease of installation, even with little or no electrical or programming experience.

• What type of wire is used in the painless wire harness?

  The Painless wire harness is designed to be used in vehicles with a General Motors - keyed steering column, or other steering columns, depending on the kit purchased. All wire is 600 volt, 125°c, TXL. Standard automotive wire is GPT, 300 volt, 80°c, with PVC insulation.

• Where do you mount a painless wire harness?

  Painless wire harness kits are designed to mount either under the dash or in the kick panel. They must be no further apart than the wiring will allow (approx. 16 inches). 4.2.4A good exercise is to lay out the wire harness on the floor beside your vehicle and identify all the connectors and wires.

• Can I reconnect the battery after installing the painless harness?

  DO NOT RECONNECT THE BATTERY CABLES UNTILL THE ENTIRE HARNESS HAS BEEN INSTALLED. At no point during the install should you power the system or reconnect the battery, fault codes will be set in the ECM if done so. Power is not to be applied to the Painless harness until the entire installation is done. ECM PROGRAMMING

• How do I contact painless performance for installation questions?

  If you have any questions concerning the installation of this product, feel free to call Painless Performance Products' tech line at 1-800-423-9696. Calls are answered from 8am to 5pm central time, Monday thru Thursday, 8am- 4:30pm Friday, except holidays.

• Where is the fuse block on a painless wire harness?

  The Painless Wire Harness is designed for the fuse block to be mounted on the driver's side, under the dash. 5.3Decide which of the following circuits you will be using in your system and where the harness groups or wires will be routed: ROUTING LOCATION AND PLACEMENT