T-Verter

Listing Results T-Verter

Frequently Asked Questions

• Which is the operating manual for T-Verter E2 series controller?

  Download Operating manual of T-Verter E2 Series Controller for Free or View it Online on All-Guides.com. This version of T-Verter E2 Series Manual compatible with such list of devices, as: E2-101, E2-1P2-H1 Series, E2-202-H Series, E2-2P5-*1 Series, E2-401-H3 Series

• How to change factory pre settings on T-Verter E2?

  Press RESET button. F_25: Return to Factory Pre-Settings = 010: Constants initialization to 50Hz system = 020: Constants initialization to 60Hz system 1. Page 42 F_29: CPU program version F_30: Last three faults 1.

• Which is the fault signal on T-Verter E2?

  F_22 = 2: At Frequency Speed Signal 3. F_21 = 3: Fault signal Terminal1 and2 of TM2 are activated at CPF, OL1, OL2, OCS, OCA, OCC, Ocd , Ocb , OVC , LVC , OHC. Page 40 F_23: Auto-restart after momentary power loss =0: auto-restart enabled =1: auto-restart disabled 1.

• Do you remove the front cover of an inverter?

  Otherwise, the inverter may experience an over-current breakdown. WARNING Do not remove the front cover of the inverter when the power is ON to avoid personnel injury caused by electrical shock. Page 8 2.

• How are variable speed drives used in energy management?

  Variable speed drives (VSDs), also called variable frequency drives, are a valuable tool for the energy manager. Typically the VSD system consists of a three-phase AC induction motor and a variable frequency power supply.

• Where to place a variable speed drive ?

  If in doubt, seek advice from the supplier. Tip – Standard VSDs should not generally be installed in hazardous areas, e.g., where dust explosions are likely. Use special equipment or locate the VSD/motor outside the hazardous area. If in doubt, seek advice from the supplier.

• How is the voltage of a variable speed drive adjusted?

  Output voltage is adjusted by changing the width and number of the voltage pulses while output frequency is varied by changing the length of the cycle. The waveform that is produced has the required voltage and frequency to produce the desired motor speed and torque, but it is not as smooth as the incoming sinusoidal source.

• What should the back EMF be on a P-07 motor?

  P-07 Motor Rated Voltage / Back EMF at rated speed (PM / BLDC) 0 250 / 500 230 / 400 V For Induction Motors, this parameter should be set to the rated (nameplate) voltage of the motor (Volts). For Permanent Magnet or Brushless DC Motors, it should be set to the Back EMF at rated speed.