Sep 23, 2016 . See how to use the Tach-It 2 Gun from Nashville Wraps! Find this product below and please subscribe to our channel! :)Tach-It 2 GUN:http://www.nashvillewraps...
Show more
See More
The CTL can accept products up to 8 inch in width and 13 1/2 inch in length and labels up to 5 inches wide and 9 3/4 inches long. Specifications. Machine: Length - 30 inch, Width - 22 inch, Height - 28 1/2 inch. Weight: 78 Lbs. Label Size: Minimum - 13/32 inch x 3/4 inch, Maximum - 5 inch x 9 3/4 inch. Label Roll Diameter: 12 inch.
Show more
See More
DIGITAL GAUGES . VOYAGER PRO. 010-ELV-192: Voyager Pro Quick Start Guide. 9200-MANUAL: Voyager Pro User's Manual. VOYAGER. 010-ELV-194: Voyager Quick Start Guide. 9000-MANUAL: Voyager User's Manual. VAPOR. 010-ELV-195: Vapor Quick Start Guide. 7000-MANUAL: Vapor User's Manual. STRIKER. 7110-MANUAL: Striker User's Manual. 010-ELV-196: Striker Quick Start Guide. …
Show more
See More
photo: T1 Tact Smartwatch, company promotional photo photo: T1 Tact Smartwatch Measurements, face and wristband T1 Tact Watch // Company Blog: latest updates | Blogs Around The Web: view latest news If you have purchased or thinking of purchasing a T1 Tact Watch, it's important you have an operations manual.When used properly this "Midnight Diamond" smartwatch can improve your efficiency in ...
Show more
See More
The Tiny-Tach™ meter can be mounted in the desired location using either sheet metal screws or by using double sided tape. For best results when using tape, be sure to clean off any dirt, grease and oil from the desired mounting location using a suitable solvent such as denatured alcohol. Find a suitable route to run the pick-up wire to the ...
Show more
See More
Tachtrol 30. The TACHTROL 30 computing tachometer has a display, is panel-mounted, can measure two independent speed input frequencies, convert them to relevant units that drive visual displays, mechanical & solid state relays and analog output. View Product Catalog.
Show more
See More
DIGITAL TACHOMETER OPERATION MANUAL ⅠFEATURES 1. It is used the microcomputer (CPU) technique and junction laser technique for one instrument combine PHOTO TACH. (RPM) &CONTACT TACH (RPM, m/min).
Next, use 16g wire and link all the coil-side cut halves together and hook to the red wire with a green stripe of the 9117 tachometer adapter. Ground the black 9117 adapter wire. The gray wire is your new tachometer signal wire. Set your tachometer as 8 cylinder (4 ppr).
CAUTION!!! The Tach Adapter cannot be used with a Capacitive Discharge Ignition (such as an MSD Ignition Control). The voltage on the coil positive must be below 18 volts. Installation
Caution: Keep wire clear of extremely hot engine parts such as the muffler, etc. Wire damage (cuts or burns) will cause the wire to short and your Tiny-Tach™ will stop working. Wire damage is not under warranty. The red wire should be wrapped around a section of the spark plug wire using 1 turn to start and try, or 3-4 turns.