Techbikes Ltd User Guide

Listing Results Techbikes Ltd User Guide

Frequently Asked Questions

• How do I make a tsdz2 programming cable?

  To make a TSDZ2 programming cable, you need a speed sensor extension cable - not just a spare speed sensor, because not all the wires coming from the motor/controller speed sensor 6 pin connector are carried through to the sensor itself. The sensors themselves only utilize a couple wires, the remaining being for lights, and programming purposes.

• How do I program my tsdz2 controller with data memory?

  The software will start in the ‘Program Memory’ tab, but the only place we are concerned with is ‘Data Memory’. Open the DATA MEMORY tab and press the ‘READ’ button to read the current parameters set to your TSDZ2 Controller. You will notice the ’00 00’s populate with values, particularly on line 00004000, as seen below:

• What is the firmware version of the tzidc-200?

  Device firmware version: 05.00.00 Further information Additional documentation on TZIDC, TZIDC-200 is available to download free of charge at www.abb.com/positioners. Alternatively simply scan this code: Manufacturer ABB Automation Products GmbH Process Automation Schillerstr. 72 32425 Minden Germany Tel: +49 571 830-0 Fax: +49 571 830-1806

• How do I change the voltage and amperage values on my tsdz2?

  Change the Voltage and Amperage Values as Desired (as described above), then press the ‘WRITE’ button to write the new parameters to your TSDZ2 Controller. That’s it! It is recommended to close and reopen ST Visual Programmer, and re-read the settings, to ensure your changes did in fact ‘write’.