Water Well Quick Guide

Listing Results Water Well Quick Guide

Frequently Asked Questions

• Do you have to test your well water?

  If you are having a new well constructed, a Water sample is required to be taken from a new well by the licensed well contractor (pages 18-20). •Test your well Water at least once for arsenic (page 21).

• How do you measure the depth of water in a well?

  You can measure the depth of Water by lowering a wetted steel tape to into the well until the lower part of the tape is under Water. A chalk coating on the last few feet of tape indicate the exact Water level. When you remove the tape from the well, you Sonic Well Sounder can read the depth of the Water directly from the dry length of tape.

• How do you test a submersible well pump?

  Move your car to enable the submersible pump to go inside the well. Move your car towards the well and allow the cap to collide with the roller. You can test the pump by attaching the starter, controller, and safety device.

• How does a water level probe work in a well?

  Electric Water level probes consist of a spool of dual conductor wire, a probe attached to the end and an indicator. When the probe contacts the Water, the circuit closes and a meter light or audible buzzer attached to the spool signals contact. Read the depth from graduated markings on the wire.

• Is a quick-start guide a quick reference guide?

  Is a quick-start guide a quick-reference guide? The quick answer: Yes! As noted above, a quick-start guide is one of the most common types of quick-reference guides. So, while not all quick-reference guides are quick-start guides, all quick-start guides are quick-reference guides.

• What is the purpose of the waters UPLC system?

  The Waters®ACQUITY UPLC™ system is intended for analyzing compounds and introducing separated samples into a mass spectrometer. When you develop methods, follow the “Protocol for the Adoption of Analytical Methods in the Clinical Chemistry Laboratory,” American Journal of Medical Technology, 44, 1, pages 30–37 (1978).

• How can I contact the manufacturer of waters?

  You can reach us at tech_comm@Waters.com. Contacting Waters Contact Waters®with enhancement requests or technical quest ions regarding the use, transportation, removal, or disposal of any Waters product. You can reach us via the Internet, telephone, or conventional mail.